Cleaning and Storing GOOD LUCK So It Lasts
Five minutes after use is cheaper than a replacement. The sequence below is the whole method.
A short cleaning and storage routine for GOOD LUCK, explained step by step, with safe materials and the storage habits that protect the battery.
The Short Answer
Wipe, wash, rinse with a damp cloth, dry for 10 minutes, store at 40 to 60 percent charge. That's the routine, and it takes 5 to 10 minutes end to end. Use mild, fragrance-free soap and warm water, keep 70 percent isopropyl for the non-porous surfaces only, and never put the device under a running tap. Dry it completely before it goes in the drawer. GOOD LUCK is simple enough that people skip the drying step, and that's the step that determines how long the surface stays intact.
The Five-Minute Routine, in Order
The order matters because each step removes something the next step would otherwise spread. Do it in this sequence and you won't have to repeat any of it.
- Wipe the body with a dry cloth while the lubricant is still on the surface.
- Apply a dime-sized amount of mild soap and work it in with your fingers, not a brush.
- Remove the soap with a damp cloth, folded once, so you're not redistributing residue.
- Wipe the control area and the charging port with a dry corner of the cloth.
- Leave it out to air dry for 10 minutes before storage.
No soaking and no dishwasher. The body is sealed, but seals are the first thing to fail when water sits against them, and a sealed device that takes on moisture doesn't dry out from the inside.
Why This Order Works
Lubricant is formulated to stay put. If water hits it first, the lubricant emulsifies and moves into the seam around the control, where it dries into a film that attracts lint and dust. Wiping first removes most of the volume while it's still accessible.
The drying step is the second reason. A device stored damp grows a biofilm on the surface within about 24 hours, and the next cleaning has to work harder to remove it. Ten minutes of air drying avoids that entirely. It's the least satisfying step and the one with the largest effect.

What Is Safe on a Soft Body
Mild soap and warm water are safe. Seventy percent isopropyl is safe on the smooth non-porous sections, but it shouldn't be poured into seams, and it shouldn't be used more than once a month as a deeper clean. Fragrance-free matters: scented soap leaves oils behind that the next wash has to lift.
Avoid boiling water, dishwashers, acetone, and household sprays. Avoid silicone-based lubricant on the body as well; the two silicones interact and the surface turns tacky over repeated contact. If the surface already feels tacky after cleaning, that's residue rather than damage, and one isopropyl pass with 30 seconds of contact usually resolves it. The limitation is that this won't fix a pitted surface, only a coated one.
Storage That Keeps It Discreet and Charged
Store it in a fabric pouch rather than a plastic bag. A pouch breathes, which matters if any moisture remains, and it keeps lint off the surface. Keep it out of the bathroom; steam cycles through a bathroom cabinet several times a day and none of that is good for a sealed electronic device.
Charge to roughly 40 to 60 percent if it'll sit for weeks. A cell left at zero loses capacity, and a cell left at full ages faster. Check the charge once a month rather than leaving it plugged in permanently. A bedroom drawer between 60 and 80 F is close to ideal, and at 11 p.m. that's also the drawer you'll actually use.

When to Replace Rather Than Clean
Replace when the surface is pitted, peeling, or cracked. Those are places a cloth can't reach, and no cleaning routine fixes a compromised surface. Replace when the battery drops below roughly half its original runtime, since a device that dies mid-session stops being used.
Clean more aggressively when you notice a smell that returns within a day of washing. That usually means residue in the seam rather than a failing device. One deeper clean with 70 percent isopropyl, a full dry, and a fresh storage spot will tell you within a week whether the problem was the routine or the device.
Who Can Skip Most of This
If GOOD LUCK lives alone in a clean drawer and comes out twice a month, a wipe and a dry cloth are sufficient; the full sequence is for weekly use or shared devices. If you share it, cleaning isn't enough on its own and you need a barrier or a second device. The trade-off is time rather than money, and the downside of skipping it is a surface that fails long before the motor does.
Small Upkeep, Long Life
The device that lasts is the one that gets dried, not the one that gets scrubbed.
- GOOD LUCK: a smooth, soft-touch body with a simple control layout, which means fewer seams to clean and no complicated sequence to remember at midnight.
- Browse the Customer Favorites collection for pieces with an easy care routine.
- Related reading: a simple routine for cleaning and storing GOOD LUCK
- how to store a toy so it lasts
- where to start with GOOD LUCK if you have never used one
Sources
- Centers for Disease Control and Prevention — general hygiene guidance for personal items.
- U.S. Consumer Product Safety Commission — lithium-ion battery storage and charging advice.
- International Electrotechnical Commission — how water-resistance ratings are defined.
This article is general education about device care, not medical advice. Follow the manufacturer's instructions where they differ.




