Cleaning GOOD LUCK Without Ruining the Finish
You clean it the way you clean everything else, and a month later the matte surface has gone shiny in patches.
The 30-second wash that's actually enough, the four products that dull silicone, and how to dry a small device without cooking the port.
The Short Answer
Warm water, one drop of unscented soap, 30 seconds with your fingers, rinse, pat dry, and 30 minutes of air with the port facing down. That's it. Skip alcohol wipes, bleach sprays, boiling water, and the dishwasher. GOOD LUCK is IPX7, so the body can be rinsed, but the charging port has to be dry before it meets a cable. The wash takes less time than finding the soap.
Why the Finish Dulls
Silicone has a matte surface with a fine texture. That texture is what makes it feel soft rather than slick, and it's the first thing to go.
Two things flatten it. Solvents strip the surface layer, and abrasion wears the texture down. Alcohol wipes do the first. A rough washcloth or a scrubby sponge does the second.
Once the texture is gone, the surface looks shiny and feels tacky at the same time, which is the confusing part. It isn't dirty. It's worn, and no amount of extra cleaning brings it back.
Think about the last time you grabbed a wipe because you were in a hurry. That's the version that does the damage, and it takes about four seconds to undo a month of careful washing.
The 30-Second Wash
Warm water, not hot. Add a drop of unscented hand soap and work it over the head with your fingertips for 30 seconds. Fingers are better than cloth here, because you can feel grit and because they don't abrade.
Pay attention to the seam where the silicone meets the housing. Residue collects there first, and it's the spot a quick rinse misses. A soft toothbrush, used lightly along the line, handles it without scratching.
Rinse until the water runs clear. Soap left on the surface is one of the reasons a device feels tacky a day after washing, and it's the easiest cause to eliminate. The 30-second wash isn't a shortcut. It's the whole procedure.
Say you wash it at the sink before bed, then put it away damp because you're tired. That's the second most common cause of a dull finish, and it's the one nobody notices until the smell starts.
Drying Is Half the Job
Pat the body with a lint-free towel, then set it upright with the port facing down so water drains away from the electronics. Leave it 30 minutes.
Don't put it in a pouch while it's damp. A closed pouch holds moisture against silicone, and that's how a clean device picks up a smell that survives the next wash. The same goes for a drawer.
If the port looks wet, wait another hour. A cotton swab at the outer edge is fine; don't push anything into the connector. GOOD LUCK is 6.8 inches, so it dries faster than a wand, but the port is still the slowest part.
What Never to Use
- Alcohol wipes. Fast, convenient, and the leading cause of a tacky surface.
- Bleach or bathroom spray. Harsh on the coating and easy to leave residue on a surface that touches skin.
- Boiling water. Warps the housing and stresses the seal.
- The dishwasher. Abrasive detergent, hot drying cycle, and parts that aren't built for it.
None of these fail loudly. They show up as a sheen, then as stickiness, then as a surface that holds dust no matter how often you wash it.
How Often, and When to Stop
Wash before and after each use. That's the baseline, and it holds up. A monthly pass with the soft brush at the seam covers what daily washing misses. Late at night, a two-minute wash feels like a chore, so keep the soap in the drawer and it stops being one.
If it still feels tacky once it's washed and bone dry, the silicone itself has changed. Replace it rather than escalating to stronger products, which only speed the decline and leave residue behind.
When This Is More Than You Need
If you use GOOD LUCK once a week, the 30-minute dry and the monthly seam clean are more than required. Soap, rinse, dry, done. The extended version is for frequent use or for anyone who has noticed a change.
The honest limitation here is that you're protecting a surface, not a seal. A crack near the head means the water resistance is gone, and no cleaning order brings it back. Skip the rinse at that point and replace the device.
Soap, Water, Air, Done
Thirty seconds of washing and thirty minutes of drying. That's the whole method.
- GOOD LUCK: IPX7 water resistance on a 6.8-inch body with a 1.5-inch head, 5 intensity levels and 3 patterns, about 40 dB, and 150 minutes of runtime from a 2-hour USB-C charge, so a wash cycle never costs you an evening.
- Browse the Customer Favorites collection for easy-care designs.
- Related reading: battery and charging care for GOOD LUCK and using GOOD LUCK without pressure.
- Next, read using GOOD LUCK on a low-sensation day.
Sources
- Planned Parenthood — general sexual health education and product care information.
- Cleveland Clinic — general guidance on cleaning personal care items.
- Centers for Disease Control and Prevention — general information on hygiene practices.
This article is for general education and is not medical advice. It does not replace guidance from a qualified professional. Follow the manufacturer's care instructions, and stop using any device with a damaged housing or seal.
