GODLIKE and Scent: What Stays on the Surface
Two weeks of use, and the handle smells like the last session even after a rinse. The setting you used has nothing to do with it.
Platinum-cured silicone doesn't absorb odor. Something on the surface does, and it's usually in one of three places you can reach in under a minute.
The Short Answer
Wash within an hour of use, not the next morning. Warm water, one drop of mild unscented soap, 30 seconds over the whole body including the seam, then dry completely before storage. The smell is almost always lubricant residue, body oil at the joint between head and handle, or a closed bag holding humidity. If it survives two washes, check the port cover and the seam for separation.
What Silicone Does and Doesn't Absorb
The surface is non-porous. Odor molecules can't settle into the material, which is why silicone is the standard for body-safe products. Anything you smell is sitting on top of it.
That's useful diagnostically. If the surface can't absorb, the smell has a location, and locations can be cleaned. The two candidates are the seam and the port cover, both of which have a gap.
There's a third possibility worth ruling out: the bag. A cotton bag that lives in a drawer picks up the room, and a drawer with a candle in it will scent everything inside. Smell the bag before you blame the device. That mistake is common and easy to fix.
The Seam Is the Suspect
On GODLIKE the head meets the handle at a joint that flexes. That joint is not a smooth surface; it's a narrow channel, and channels collect what a rinse leaves behind.
Run a fingertip along it after washing. If it feels tacky, there's residue. A soft toothbrush with soap, used only on the seam, lifts it in about 20 seconds. Don't scrub the smooth body; there's nothing there to lift.
Dry the seam first, before the rest of the body. It holds water longer than the smooth surface, and a damp seam is where the musty smell starts.
A Cleaning Sequence That Removes the Cause
Thirty seconds of contact, not a rinse. Warm water, one drop of soap, fingers moving over the entire 8.3 inches including the curve and the seam. Rinse until the surface stops feeling slippery, which takes longer than people expect.
Then dry with a lint-free towel and leave it in open air for 10 minutes with the port cover open. That last step is the one that prevents the musty smell that returns a day later. Skip it and the wash looks successful until tomorrow.
Drying and Storage
A pouch is for travel. A drawer is for storage. A sealed bag in a warm drawer holds whatever evaporated off the device, and the inside of the bag transfers it back.
Cotton is better than nylon. Keep it away from scented items: soap, candles, sachets, and soft plastic cases. Silicone can pick up plasticizer from close contact with some plastics, and that transfer doesn't wash out.
Late at night, when you're putting it away in a hurry, the bag is usually the last thing you think about. Make it the first. A dry device in a clean cotton bag will stay neutral for weeks; a damp one in a nylon pouch will not.
When the Smell Is a Warning
A sharp chemical smell near the port is not a cleaning problem. It can indicate a failing cell or a seal that has let moisture in. Stop using it, don't charge it, and check whether the body is warm while switched off.
A musty smell that returns within 24 hours of cleaning points to moisture under the port cover. Leave it open in a dry room for a day and check again. If it persists, the seal has probably failed, and that's a replacement question rather than a maintenance one.
Don't try to mask it. A scented wipe or a drop of essential oil adds a second smell on top of the first, and silicone will hold the new one just as readily. Fix the cause or replace the device.
Who Doesn't Need This
If you use it once a month and store it in open air, a 30-second wash is enough. Skip the monthly seam brush and the drying timer. The routine matters most for weekly use in a humid room.
The honest limitation: this is more cleaning than some people want, and the storage rules are the part that actually keeps the surface neutral. If the upkeep makes you use the device less, simplify. A slightly imperfect clean beats a device that lives in a drawer because the routine feels like a chore.
One Seam, Thirty Seconds
A non-porous surface is easy to keep neutral. The joint is the only place that needs attention.
- GODLIKE: platinum-cured silicone, a sealed body, 6.2 oz, 9 speeds, about 45 dB, and one seam to check with a fingertip.
- Browse the Customer Favorites collection for pieces that are easy to keep clean.
- Related reading: storing GODLIKE so the silicone stays smooth and cleaning it without damaging the surface.
- New this week: the nightstand drawer test for GODLIKE.
Sources
- GETAUVE product documentation - material, seam construction, and care instructions for GODLIKE.
- U.S. Consumer Product Safety Commission - guidance on silicone devices and battery safety.
- American Sexual Health Association - general education on device hygiene.
This article is general education and not medical advice. If an odor persists after cleaning, or the body feels warm while switched off, stop using it. Speak with a clinician about irritation that doesn't settle.
